Drum Okidata
Both Xerox and Okidata have taken the world by storm with their innovative technologies. However, there are still many error codes that baffle users. Here we speak of common error codes and their troubleshooting tips.
Error message: job canceled
This error message occurs when was deleted a scan before it could be completely transferred from error can occur because the folder with the. ick was not removed properly after exploration. It could also occur if the destination disk is full. Perhaps the volume directory or database analysis has been incorrectly under the Xerox device. Try removing the. Ick folder and resubmit exploration.
Error Message: Invalid protocol
This type of message error occurs when the particular protocol has not been enabled within the printer Xerox. It is necessary to activate the particular protocol.
Error message: File Transfer Error
This type of error message occurs when the network is down or if the disk is full or if the path of exploration database is not correctly specified. It is necessary to check the status of the network, and the amount of disk space.
Error message: The system canceled job
This error message occurs when the sensors to the feeder document is defective. It could also happen if these sensors were not installed correctly or if a person is lifting the edge of a large document travel sensor. It is necessary to send the search and if the problem is not because of one person, then it's definitely a hardware problem or configuration.
Error Code: 71
This error code on the device Okidata indicates a fuser error. Make sure to replace the fuser. Or try the plaque control main.
Error message: Error Engine
This usually happens in the laser Oki 400 series. Code means that the fuser temperature is low. You need to replace the fuser or the thermistor inside the fuser.
Error message: fatal error 140
This error code 140: the drum top and bottom of the image process is not working properly. The error code 140: the error is with the yellow drum, while 141 and 142 indicate problems with the magenta and cyan, respectively. Try reseating the battery to the first image. Then try reseating the toner cartridges. You will also need to reinsert the spring Assembly sensor for the contact.
Error Code: 020
This is another grave error code indicating a power problem on the network. You need sure the cord is in direct relation to the outlet on the wall. You can also try replacing the cable or use a different network if this does not solve it.
About the Author:
This Article is written by James Kara Murat from PrintCountry.com, the contributor of Printer Reviews. More information on the subject is at Xerox, Okidata Error Codes and How to Fix Them, and related resources can be found at Xerox Toner Cartridges.
Article Source: ArticlesBase.com - Xerox, Okidata Error Codes and How to Fix Them
Drum Okidata
Drum Okidata
