Brother Laser

Brother offers a complete selection of fax machines, printers and multifunction printers. However, the list of common error codes found in they can confuse even the most experienced troubleshooter. Here we explain common errors and how to fix them.

E50 Error Code: damage to the fuser unit

This can happen when the heat roller has been destroyed code E51: Fault protection in the laser beam

This error code indicates that the beam, mirrors or the lid is not properly positioned. Be sure to adjust these in order to get the Brother laser printer back to work again.

S05 Error code: Error with the data bus

This type of error code means that the data transmission in the parallel port affected. Most times, this problem can be handled effectively by simply restarting the printer.

Error code machine 'error': issues on board

This type of error code usually indicates strong continuous beeping on your brother fax machine. You need to check in welds to see if they are cold on the place of supply of energy. It is also necessary to check these joints in all the other boards before going to a replacement. If you find no improvement even after replacement then try to change the capacitors on the board for the supply of energy.

Pages from an error message 'Black'

This error code typically implies black pages are printed on a laser printer from Brother. This is often the case in the Brother 960 and Brother 1260 model varieties. This means that the HVPS is guilt. You will have to replace the diodes below and put jumper wire instead. Diodes D31, D33, D30 and D32 will be replaced. For the jumper wire will have a width of 22.

Route error message 'check'

The error lies in the paper path that can be rectified by taking paper hopper. Then simply clean the paper ejection rollers.

Error Message Issues 'Cutter'

This type of error message is displayed when there is not a paper jam or that the device not to cut the paper properly. You need to check Spring court if it is defective or not. Be sure to remove the cutter and clean and lubricate it. If the problem persists try replacing the gear train. fax. Be sure to check the scanning glass and mirrors are clean. If these are clean, then the issue is with the camera. You could try the solution of problems with just disconnect the fax machine Brother for at least a night. You can only keep Shell out a replacement for the camera!

About the Author:

James Kara Murat, the contributor of Printer Reviews. More information on the subject is at Brother Laser Printer, Fax & Brother Multifunction Printer Error Codes & How to Fix Them, and related resources can be found at Brother Ink Cartridges.

Article Source: ArticlesBase.com - Brother Laser Printer, Fax & Brother Multifunction Printer Error Codes & How to Fix Them

Brother Laser

Brother Laser